Mercury Verado 6, 8, 10-cylinders with dual-ram power trim/tilt systems use TWO Universal m-y wedge units.

INSTALLATION INSTRUCTIONS FOR M-Y WEDGE UNIVERSAL DUAL-RAM POWER TRIM/TILT SYSTEMS.

1. Trim outboard to up position.
2. Simply push the Universal m-y wedge on each power-tilt rod and it will pop or click into place.
3. Trim outboard down until the rubber begins to compress.
4. To remove Universal m-y wedge simply trim outboard to up position and remove.
5. Store Universal m-y wedge in any boat compartment for convenience.

NOTE: The Universal m-y wedge can be cut to size, if your outboard sits too high or you have problems with tilting your motor high enough to install the unit. Simply cut the Universal m-y wedge using a miter or hack saw. You normally don't need to cut off more than an inch.

WORKS ON:

• Mercury Verado 6, 8, 10 cylinder with dual-ram trim/tilt system.
• Other Outboards with dual-ram trim/tilt system.